Projector Hanger
An optimized bracket to hang my projector from my dorm room ceiling without causing (almost) any permanent damage. You’re welcome Bates Dorms.
Context
I wanted to put a projector in my dorm room because I didn’t want a TV cluttering up a room already limited in space. However, the only place that really made sense was to hang it from the ceiling. Knowing that I couldn’t screw a mount into my ceiling in my dorm, I needed to find another way to secure the mount. My room did come with an overhead light, and after removing the plastic shield I was left with a round metal ring firmly affixed to the ceiling. It was the correct distance from the screen, and already centered in the room. I decided that this would be the perfect location for the projector. The challenge was to design a custom mount that attached to the ring, minimized damage to it, and could be removed easily.
Content
I started in Fusion 360 by modeling what I knew: the 17" aluminum ring and the projector’s mounting bolt pattern. I then designed a central hub to connect the projector to four support members, and clips to connect the supports to the ring. I drilled four 5 mm holes in the ring so the clips could be mechanically fastened, which I judged more secure than friction or adhesive and which was the mount’s only modification to the fixture. For the supports, I set up a Fusion generative design study with the projector’s 8 lb weight as the load, mass reduction as the objective, and a minimum safety factor of 2 as the constraint, with the ring and hub interfaces as fixed boundaries. I selected a result that met that threshold with the least material and printed the supports in Tough 2000 resin on my school’s Formlabs SLA printer. I chose SLA because it produces nearly isotropic parts, and better suits organic geometry, and Tough 2000 for its durability and heat resistance near the projector. The hub and clips are simpler shapes, so I printed them in ABS on an FDM printer, oriented so the layers run parallel to the stress, and ABS for its toughness and heat resistance.
Conclusions
The mount held the 8 lb projector for approximately ten months with no visible deformation or loosening. It was removed by taking out the four fasteners, and by replacing the plastic lamp shade there was no change to the ceiling light or its function. The project showed me how much material and process choices matter when failure is a projector falling from the ceiling. If I did it again, I would [change, e.g., add a safety tether, reduce mass further, use metal clips]. By carefully considering my materials and processes, I made a durable and functional part that stood the test of time and solved my problem.